Troubleshooting Guide - Heath Zenith DualBrite Manual Del Usuario

If you experience a problem with your coach light, follow this guide before returning it to
SYMPTOM POSSIBLE CAUSE
Light will not 1. Light switch is turned off.
come on.
2. Bulb is loose or burned out.
3. Fuse is blown or circuit breaker
is turned off.
4. Daylight turn-off is in effect
(recheck after dark).
5. Incorrect circuit wiring, if this
is a new installation.
6. Re-aim the sensor to cover
desired area.
Light comes on 1. Light control may be installed
in daylight.
in a relatively dark location.
2. Light control is in Test. (Set
control switch to an ON-TIME
position.)
Light comes on
1. Light control may be sensing
for no apparent small animals or automobile
reason.
traffic (re-aim sensor).
2. Sensitivity is set too high.
(Reduce sensitivity.)
No Service Parts Available for this Product
See your Canadian Tire retailer for warranty information.
598-1207-01
All manuals and user guides at all-guides.com

TROUBLESHOOTING GUIDE

the retailer.
SYMPTOM POSSIBLE CAUSE
Light stays on 1. The sensor is pointed toward
continuously.
2. Light control is in Manual Mode.
3. Light control is in D
4. Sensitivity is set too high. (Re-
Light flashes
1. Sensor is in the Test mode.
on and off.
2. Heat being reflected from other
Light does not
1. Nearby large, light-colored
stay on in Man-
ual mode.
7
a heat source like an air vent,
dryer vent, or brightly-painted
heat-reflective surface. (Re-aim
sensor.)
(Switch to Auto.)
ual
mode.
duce sensitivity.)
(While in TEST mode, light only
stays on for 5 seconds.)
objects may be affecting the
sensor. (Re-aim sensor.)
objects reflecting light may
trigger the shut-off feature. Do
not point other lights at the
sensor.
B
®
rite