Publicidad
Idiomas disponibles
Idiomas disponibles
Illustration 4
Illustration 5
Main unit
7
/
" long
8
screws
7
/
" long
8
screws
Desk end
panel
1
/
" long screw
2
Illustration 6
Main unit
Curved
edge
Tapered
end
Front edge of
return
42-2364G
SIDE 2 OF 2 (1/06)
Leg leveler
End panel
Return
mounting
bracket
Skirt mounting
bracket
Filler strip
Seam
RETURN
Leg Leveler Installation (refer to Illustration 4):
1. Insert threaded end of leg leveler (from hardware pack)
into hole in bottom edge of end panel.
2. Turn leg leveler clockwise until leg leveler is flat against
end panel.
3. Repeat this procedure for remaining leg leveler.
Attaching Return to Main Unit (refer to Illustration 5):
1. Install return mounting bracket, removed from return
unit, onto main unit as shown. Use the drill and
power nutdriver to install five
Return
hardware pack) through holes in mounting bracket and
into pre-punched holes along front edge of main unit
top. Fully tighten screws.
2. Use the drill and
screw securing return skirt mounting bracket to bottom
edge of skirt. Save screw and skirt mounting bracket for
later use.
3. Place skirt mounting bracket under table desk end
panel as shown.
4. Use two or more people to position return. With return
in the upright position, rest top of return onto mounting
Return
bracket attached to the table desk. Install four
skirt
screws (from hardware pack and removed from bottom
of return top) but do not fully tighten.
5. Use the drill and
screw, removed from skirt mounting bracket, , through
return skirt mounting bracket and into bottom edge of
return skirt. Do not fully tighten screw.
6. After leveling and adjusting the alignment of return, use
the
/
" power nutdriver to tighten all screws.
1
4
Filler Strip Installation (refer to Illustration 6):
1. Remove protective backing from mounting tape on filler
strip.
2. With curved edge facing main unit, align tapered end of
filler strip with front edge of return.
3. Carefully insert filler strip into seam between main unit
and return.
/
" long screws (from
7
8
/
" power nutdriver to remove
1
4
/
" power nutdriver to install
1
4
/
"
1
4
/
" long
1
2
7
/
" long
8
/
" long
1
2
Publicidad
