Publicidad
Idiomas disponibles
Idiomas disponibles
Transporting the JAZZ EASyS Pushchair
The JAZZ EASyS can be folded for transport in the luggage area of a vehicle.
The JAZZ EASyS has been successfully impact tested against international standard
ISO 7176/19 and ANSI/RESNA WC/Vol.1 – Section 19 6/22/99 Draft and may be
used as a vehicle seat.
IMPORTANT: When used as a vehicle seat the following instructions
must be followed.
Preparing the JAZZ EASyS for transport:
1. Remove the following (if fitted); pommel, play tray, rain hood, sun canopy,
grip rail, accessory bag and shopping basket contents.
2. Position the pushchair correctly in the vehicle over the floor track with
the front of the pushchair facing towards the front of the vehicle (in the
direction of travel). Put the brakes on.
3. Always ensure that the seat of the pushchair is in the most upright position
(not reclined).
Securing the JAZZ EASyS in a Vehicle:
1. The pushchair must be secured in a vehicle using a 4-point tie down system
that complies with either ISO 10542 Part 2, SAE 2249 or DIN 75078/2.
(Such restraints are manufactured by Unwin Safety Systems and Q'Straint)
2. Vehicle operators and/or assistants should be fully trained in the use of
wheelchair tie-down and occupant restraint systems.
3. The two front tie-downs must be attached left and right side to the steel ring
located on each front castor mounting boss as shown in fig. A.
4. The two rear tie-downs must be attached to the two secureness points
located on each side of the pushchair frame as shown in fig. B.
fig. A
fig B
Publicidad
