Stanley FatMax FMC620 Manual De Instrucciones página 9

TO REMOVE BATTERY PACK: Depress the battery
release button as shown in figure D and pull battery
pack out of tool.
OPERATING INSTRUCTIONS
TRIGGER SWITCH & FORWARD/REVERSE
BUTTON - FIGURE E
The drill is turned ON and OFF by pulling and
releasing the trigger switch (1) shown in
figure E. The farther the trigger is depressed, the
higher the speed of the drill. A forward/reverse control
button (2) determines the direction of the tool and
also serves as a lock off button. To select forward
rotation, release the trigger switch and depress the
forward/reverse control button. To select reverse,
depress the forward/reverse control button in the
opposite direction. The center position of the control
button locks the tool in the off position. When
changing the position of the control button, be sure
the trigger is released.
ADJUSTING TORQUE CONTROL - FIGURE F
This tool is fitted with a torque adjustment collar (3)
to select the operating mode and to set the torque
for tightening screws. Large screws and hard
workpiece materials require a higher torque setting
than small screws and soft workpiece materials.
• For drilling in wood, metal and plastics, set the
collar to the drilling position symbol
• For screwdriving, set the collar to the desired
setting. If you do not yet know the
appropriate setting, proceed as follows:
• Set the collar to the lowest torque setting.
• Tighten the first screw.
• If the clutch ratchets before the desired result is
achieved, increase the collar setting and continue
tightening the screw. Repeat until you reach the
correct setting. Use this setting for the remaining screws.
Your drill has hammer action which is engaged by twisting the torque collar to the
HAMMER ACTION
hammer symbol
DUAL RANGE GEARING - FIGURE G
The dual range feature of your drill allows you to shift
gears for greater versatility. To select low speed, high
torque setting (position 1), turn tool off and permit to
stop. Slide gear shifter button (4) away from the
chuck. To select the high speed, low torque setting
(position 2), turn tool off and permit to stop. Slide
gear shifter button towards the chuck.
NOTE: Do not change gears when tool is running. If
you are having trouble changing gears, make sure
that the dual range gear button is either completely
pushed forward or completely pushed back.
. Use hammer action when drilling in masonry.
D
E
F
G
9
2
1
3
4