Led Light - Black and Decker BDET700 Manual De Instrucciones

The green wire detection LED indicator (4) will light up indicating the wire detection function
is activated.
Keep the wire detection button depressed.

When an AC source is located, the red LED indicators (4) will flash and the buzzer will
sound. The flashing and buzzing will increase as you move the tool closer to the AC source.
After detecting the AC source turn off the power at the breaker panel, and confirm that

there is no power at the outlet or fixture before initiating any repairs.
Note: Static charge may interfere with detection on both sides of the wire, resulting in limited
accuracy.
Using the pliers (fig. D)
The tool is fitted with pliers to cut wires and aid in DIY applications. Wire strippers (12) and
wire cutters (11) are accessible when the pliers are open.
To open the pliers slide the handle release switch (9) backward.

To close the pliers handle, hold the handle against the tool and slide the handle release

switch forward.
Warning! Do not cut or strip live wires. Before stripping, cutting and working with wires turn
off all power to avoid electrical shock.
Warning! Always wear eye protection and gloves.
Wire stripping (fig. E)
The tool is fitted with a wire stripper for stripping 1.0, 1. 5 and 2.5 mm
Select the opening of stripping that matches the wire size.

Clamp the wire stripper around the wire.

Hold the wire firmly and slowly pull back the tool.

Using the sheath splitter (fig. F)
The tool is fitted with a sheath splitter to split cables.
Push the cable into the sheath splitter ensuring the centre of the cable is pushed against

the sheath blade.
Push the cable further against the sheath blade and let it slit the cable.


LED light

The tool is fitted with LED lights on both ends to aid visibility.
To illuminate the LEDs on the front, push the switch (7) forward.

To illuminate the LEDs on the back, push the switch (7) backward.

ENGLISH
wire sizes.
2
11