MELICONI PRATICO 2 Libro De Instrucciones página 10

When the device reacts check whether the other buttons are operating correctly too.
If they do, the remote control is ready to use.
If they don't, you are probably using an incorrect code destined for a very similar device; at this point
ignore the SMS list and consult the SETTING CODES USING A MANUAL CODE section to fi nd a more suitable
code.
NOTE: If you don't receive an SMS on your cell phone or if the message says ERROR / NO CODE,
it means the system has not been able to process the data you have sent. Do not try sending
another SMS use the SETTING CODES USING A MANUAL SEARCH procedure instead.
SETTING CODES USING A MANUAL SEARCH
(only to be performed if the specifi c code could not be found)
1. Switch on the device and select a programme.
2. Press and hold down for 6 seconds the device selection
button corresponding to the device you wish to enter the
code for.
3. Release the button. The indicator light will fl ash. Point
the remote control at the device and press the ON/OFF
button. If the device does NOT switch off, press the
same button again slowly (it may be necessary to press
the button several times).
4. When the device responds correctly, press OK. Three
long fl ashes indicate that the operation has been carried
out correctly.
Check that the other buttons correspond to the functions of the original remote control; if not, it is likely
that the code found is incorrect, but is used for a very similar device. In that case, repeat the procedure
from point 2.
If the manual search for the code is successful, obtain the code in use by following the DISPLAY CODE IN
USE procedure and make a note of it inside the battery cover.
NOTE: During the search the indicator stops fl ashing and the remote control exits the programming mode
in the following cases:
• if for 12 seconds the button indicated is not pressed or if another button is pressed
• if the list of codes to fi nd is terminated. If this happens, go to the www.meliconi.com website
8
CHECK
6 SEC.
or