Park Tool CM-25 Instrucciones

PARK TOOL CO.
5115 Hadley Ave. N., St. Paul, MN 55128 (USA) www.parktool.com
Before You Begin Slide handle (#7) up firmly into slot in CM-25
Professional Chain Cleaner body (#1). With enclosed 1.5mm hex wrench,
tighten set screw (#3) in handle just enough to secure the handle to the
body of the CM-25. Place newspaper or other floor protection under
work area. Remove excess mud, dirt and sand from chain and other
components with Park Tool GSC-1 GearClean™ Brush or rag. Shift to
smallest rear cog. Shift to a chainring or tilt bike in stand to make lower
section of chain horizontal.
To Use
1. With the handle of CM-25 facing towards you, flip silver locking lever to
down position.
2. Open lid and fill with CB-4 Chain Cleaning Fluid to lower ridge, inside
bottom half of CM-25 (approximately 2 oz.).
3. Attach the CM-25 around lower section of chain as shown, making sure
chain seats in between brushes, close lid and then lock in place with
silver lever in up position.
1
4
5
3
6
2
1
11/16
CM-25
Instructions / Instructions / Anleitung / Instrucciones
CM-25 Professional Chain Scrubber
2
10
8
7
4. Crank pedals backwards 30 revolutions
5. Empty CM-25 and rinse with water. Squeeze fluid from sponge.
6. Repeat steps 1–4.
7. Dry and then lubricate chain.
Tips
• Water and a small amount of dishwashing detergent may be substituted
for cleaning fluid in step 6.
• Replacement brushes and sponges are available. Ask your favorite
retailer for Park Tool part # RBS-25.
Caution
• Park Tool CB-4 Bio ChainBrite Chain Cleaning Fluid is recommended.
• Do not use gasoline, petrol, kerosene or other highly volatile or flammable
solvents.
• Do not store cleaning fluid in CM-25.
• Dispose of spent cleaning fluid responsibly.
3
Parts / Pièces / Teile / Partes
Ref. # Part #
1 2340 Base
2 2344 Retaining Clip
3 2345 Button Head Socket Cap Screw
4 2346 Top
2347 Pivot Bushing
5
6 2348 Pivot Screw
7 2351 Handle
8 1158-3 Washer
9 2343 Set Screw
10 RBS-25 Brush Assembly
11 2342 1.5mm Hex Wrench
9
11
PARK TOOL® and the color BLUE are registered trademarks of Park Tool Co.
Description
© 2016 Park Tool Co.
Qty.
1
1
1
1
2
2
1
2
1
1
1