Battery Safety - Stanley STHT77587 Manual Del Usuario

WARNING:
GB
This tool is not a measuring device and should
not be used as a substitute for a voltmeter.
WARNING:
The LED or Live Wire Detection symbol on the
display is just an indicator and in some situations
the voltage detection option may not accurately
indicate the presence of voltage in a wall in the
event of internal device failure or improper operation,
and therefore should not be solely relied upon for
identification of the presence of hazardous voltages.
Other evidence, such as construction blueprints or
visual identification of wiring or conduit entry points
should also be utilized.
Always follow proper safety practices and use
a separate detection method to verify a de-energized
condition prior to commencing work.
WARNING:
Always turn off AC power when working near wiring.
WARNING:
Shielded wires or wires in metal conduits, casings,
metalized walls, or thick, dense walls may not be
detected.
CAUTION:
Use personal protective equipment. Always wear
eye protection. Depending on the work conditions,
wearing protective equipment such as a dust
mask, non-skid safety shoes, hard hat, and hearing
protection will reduce the risk of personal injury.
IMPORTANT SAFETY NOTICE
Ensure proper detection of live wires. Always hold the Stud
Sensor STHT77587/STHT77588 in the handle area only. Grasp
between fingers and thumb while making contact with your palm
(Figure ).
C

Battery Safety

WARNING:
Batteries can explode, or leak, and can cause
injury or fire. To reduce this risk:
• Carefully follow all instructions and warnings on the battery
label and package.
• Always insert batteries correctly with regard to polarity
(+ and –), as marked on the battery and the equipment.
6
• Do not short battery terminals.
• Do not charge disposable batteries.
• Do not mix old and new batteries. Replace all batteries at the
same time with new batteries of the same brand and type.
• Remove dead batteries immediately and dispose of per
local codes.
• Do not dispose of batteries in fire.
• Keep batteries out of reach of children.
Installing AAA Batteries
Load two new AAA batteries in the STHT77577 or STHT77588
stud sensor.
1.
On the bottom of the stud sensor, lift up the latch
(Figure ) to unlock the battery compartment cover.
B 1
2.
Move the cover upward (Figure
once it separates from the stud sensor.
3.
Insert two new, high-quality AAA batteries, making sure to
position the - and + ends of each battery as noted inside
the battery compartment (Figure
4.
Place the cover back on the stud sensor.
• Insert the two pins at the top of the cover into the holes
in the stud sensor (Figure
• Slowly lower the cover and press down until the latch
locks securely on the stud sensor (Figure
5.
Press to test the stud sensor.
• All the LEDs except the green Power
illuminate for a second and then turn off.
• Whenever you press
should illuminate to indicate that the batteries are good.
If this LED blinks or does not illuminate, change the
batteries.
Using the Stud Sensor
The stud sensor will help you find wood or metal studs, and AC
voltage behind drywall.
• STHT77587 will work on up to 3/4" (19mm) thick drywall.
• STHT77588 will work on up to 1.5" (38mm) thick drywall.
• STHT77587 and STHT77588 will detect AC voltage through
up to 2" (50.8mm) thick drywall.
) and remove it
B 2
).
B 3
).
B 4
).
B 5
LED should
, the green Power LED