Philips SBCRU440/85 Instrucciones De Manejo página 4

RU240- page 4
2 Press to start the search. Each time the green LED blinks, another
code is sent. When the right code is found, the equipment switches
off (the VCR will stop playing).
3 Immediately press
If you missed the correct code because the search went too far, switch
the equipment back on, then press
code again. Press
off again.
4 Once you've found the correct code, press
The green LED blinks twice.
That's it! Now, switch the equipment manually on again, then press a
few keys on the remote to check that the equipment responds correctly.
In the rare instance that it doesn't, try again from step 1 to find a better
code.
Note that code! To save time if you ever need to setup again, make a
note of the correct code inside the battery case and in the back of this
booklet. In case you have forgotten to note the code you can still 'read
out' the code from the remote. Here's how:
1 Make sure you've selected the right mode (with
Then press and release
lights up.
2 Press . The green LED goes out.
3 Press 1 and count the number of times the green LED blinks. This
is the first digit of the 3-digit code. (No blinks means the digit is
zero.)
Press 2 and count the number of blinks for the second digit.
Press and count the number of blinks for the third digit.
3
ADVANCED TIPS AND TRICKS
TO CHANGE AUDIO MODE TO CONTROL A SECOND TV
The AUDIO mode on this remote is used to control audio equipment. It
is factory preset to control a CD-player, but you can change it to control
a second TV, for example.
Before you start, press
second TV is switched on.
1 Press and hold
until the green LED lights up.
2 On the keypad, enter 992.
3 Press to select TV mode, then press any key except
more. That's it!
Don't forget you now need to setup the remote to operate this second
TV - see Getting started.
TO CONTROL THE SECOND TV'S VOLUME
If you have installed a second TV under AUDIO mode, you can also
control that TV's volume when you are in VCR mode.
4
to stop the search.
P
(down) repeatedly until the equipment switches
P
and
to select AUDIO, and make sure the
and 6 at the same time -for about 3 seconds-
(down) to send the previous
to lock it in memory.
6 at the same time; the green LED
).
once