PoolMaster 52508 Instrucciones De Montaje página 2

8
Shower Head
7
Upper Shower
Head Bracket
5
Lower Hose Bracket
3
Shower Hose
Shower On-O Valve
2
Lower Pipe Assembly
1
Support Base
Rubber
Mallet
Screwdriver
9
Hose Guide Bracket
6
Upper Pipe Assembly
4
Middle Pipe Assembly
Set Screw
10
Quick Connector
with Washer
Set Screw
Base Cap
Adjustable
Wrench
Phillips
Fill the support base with water or sand. Insert
1
the base cap.
Insert the lower pipe assembly into the base
2
and secure with (1) set screw.
Attach shower hose to shower on/o valve
3
(shower hose threads come with te on tape
pre-applied). The adjustable wrench may be
needed to tighten shower hose into on-o valve.
Insert the middle pipe assembly into the lower
4
pipe assembly aligning the pre-drilled holes and
secure with (1) set screw. A rubber mallet may
be needed.
5 Attach the lower hose bracket onto the middle
pipe assembly. Make sure the large hook on the
hose bracket is facing the same direction as the
quick connector.
6 Insert the upper pipe assembly into the middle
pipe assembly.
Insert the upper shower head bracket onto the
7
upper pipe assembly.
Connect the hose to the shower head, mount
8
shower head to the upper shower head bracket of
the upper pipe assembly. NOTE: Snap hose into
bracket and slide shower handle in place. Adjust
angle to your preference.
Attach hose guide bracket half way between
9
the lower hose bracket and the upper shower
head bracket. Snap in the shower hose to both
hose guide brackets.
Remove quick connector by sliding sleeve in
10
direction shown to release spring tension.
Attach garden hose to the connector and
re-attach quick connector by sliding over o-ring.
Sleeve (move sleeve in direction of arrow)
O-Ring
Installed
2