Fitting The Magazine; Removing The Fastener Guide; Inserting The Fastener Guide - Hilti GX 2 Manual De Instrucciones

Note
The magazine cannot be removed if the nail pusher has not been pulled back
until it engages in the rearmost position.
2. Remove the loose nail strips from the magazine.
3. Release the magazine locking catch.
4. Pivot the magazine about the pivot point towards the front.
5. Detach the magazine.
WARNING
Risk of finger injury! Fingers could be pinched when the nail pusher is released.
▶ When disengaging the nail pusher, do not release it and allow it to jump forward.
Guide it forward slowly as far as it will go.
6. Release the nail pusher and guide it forward as far as it will go.

8.4 Fitting the magazine

1. Pull the nail pusher back until it engages.
Note
The magazine cannot be fitted if the nail pusher has not been pulled back until it
engages in the rearmost position.
2. Engage the front end of the magazine with the fastening tool.
3. Pivot the magazine towards the fastening tool as far as it will go.
4. Close the magazine locking catch.
WARNING
Risk of finger injury! Fingers could be pinched when the nail pusher is released.
▶ When disengaging the nail pusher, do not release it and allow it to jump forward.
Guide it forward slowly as far as it will go.
5. Release the nail pusher and guide it forward as far as it will go.

8.5 Removing the fastener guide

1. Remove the battery. → page 9
2. Remove the gas can. → page 9
3. Unload the magazine. → page 9
4. Move the fastener guide release slider to the «EJECT» position.
5. Remove the fastener guide.

8.6 Inserting the fastener guide

1. Remove the gas can. → page 9
2. Remove the battery. → page 9
3. Unload the magazine. → page 9
4. Push the fastener guide release slider in the direction of the arrow into the «EJECT»
position and hold it there.
Note
The fastener guide can be inserted only when the slider is held in the «EJECT»
position.
10