Milling Operation; Fitting The Copy Sleeve; Milling With The Copy Sleeve; Milling With The Rip Fence - Parkside POF 1200 D3 Traducción Del Manual De Instrucciones Original

Milling operation

Adjust the desired milling depth as described
above .
♦ Place the appliance onto the workpiece and
switch it on .
♦ Release the clamping lever
clockwise and pushing the appliance down-
wards until the depth stop
stop .
♦ Lock the appliance by turning the clamping
lever anticlockwise .
♦ Carry out the milling process at a uniform speed
and contact pressure .

Fitting the copy sleeve

♦ Fit the copy sleeve
below .
♦ Fasten the copy sleeve
using the two screws
adapter .
Ensure that you insert the copy sleeve
right way around – the race
downwards (see fig . C) .

Milling with the copy sleeve

NOTE
► The template must be at least as high as the
race of the copy sleeve
► Select a smaller cutter than the inner diameter
of the copy sleeve .
You can use a copy sleeve
onto the workpiece .
♦ Place the router with the copy sleeve on the
template .
♦ Release the clamping lever
clockwise and lower the appliance until the
previously set milling depth is reached .
♦ Now guide the appliance around the template
with the copy sleeve protruding . Do not exert
excessive pressure when working .
POF 1200 D3
by turning it
sits on the step
into the skid plate from
onto the base plate
of the dust extraction
the
must be facing
.
to transfer templates
by turning it

Milling with the rip fence

♦ Push the rip fence
dimension into the guide rails
plate and tighten the locking screws
♦ Place the rip fence
workpiece (see Fig . E) .

Adjusting the rip fence (fig . H)

Changing the width of the sliding jaws
♦ Loosen the screws for the sliding jaws
standard Phillips screwdriver (not supplied) .
♦ Move the sliding jaws as desired .
♦ Retighten the screws for the sliding jaws
Fine adjustment of the rip fence
♦ Undo the fixing wing screw
♦ Turn the dial to set the desired distance . One
turn corresponds to 1 mm . You can also read
the distance on the scale
less than 1 mm, you can orient yourself using
the freely rotating scale ring
♦ Retighten the fixing wing screw

Milling with a compass

♦ To do this, slide the rip fence
180° (see fig . G) into the guide rails
base plate according to the required dimen-
sion .
♦ Tighten the locking screws
♦ Set the centring point
and tighten it using the wing screw (see fig . G) .
Counter the centring point
the oblong hole of the open-ended spanner
♦ Stab the centring point
centre point of a circle .
♦ Check the setting by means of a practical test .
according to the required
on the base
.
onto the edge of the
with a
.
.
. To set values of
.
.
turned by
on the
.
into the rip fence
to tighten it using
into the marked
GB │ MT │ 51
.
■