Air Supply - Napa 6-769 Manual De Instrucciones

AIR SUPPLY

Tools of this class operate on
a wide range of air pressures.
It is recommended that air
pressure of these tools
measures 90 PSI at the tool
while running free. Low
pressure (under 90 psig; 6.2
bar) reduces the speed of all
air tools. Low air pressure
not only wastes time, but
also costs money. Higher pres-
sure (over 90 psig; 6.2 bar)
raises performance beyond
the rated capacity of the
tool, which will shorten tool
life because of faster wear
and could cause injury.
Always use clean, dry air.
PLEASE REVIEW ALL WARNING INSTRUCTIONS PRIOR TO OPERATION. SAVE THIS MANUAL FOR FUTURE REFERENCE.
6-769
6_769_man040804.indd 3
Dust, corrosive fumes and/
or water in the air line will
cause damage to the tool.
Drain the air tank daily.
Clean the air inlet filter
screen on at least a weekly
schedule. The recommended
hookup procedure can be
viewed in the above figure.
Air Regulator
Knob
Air Inlet
3
The air inlet used for
connecting air supply, has
standard 1/4" NPT American
Thread. Line pressure should
be increased to compensate
for unusually long air hoses
(over 25 feet). Minimum
hose diameter should be
1/2" I.D. and fittings should
have the same inside
dimensions and be
tightly secured.
Rev. 04/08/04
7/30/04 9:59:28 AM