HURAKAN HKN-HVC10 Manual Del Usuario página 6

EN
DEAR ALL,
Thank you for choosing our brand product. To ensure the safety and maximum lifetime of the
device, please read this manual. We strongly recommend you to keep it for the entire lifetime of
the product.
1. Safety rules
ATTENTION!
Before using the product, please read this manual carefully. During operation, these instructions
must be stored together with other instructions and manuals securely in a place accessible to
personnel. To avoid personal injury and damaging the equipment, all the following safety
regulations must be strictly observed.
⚫
Do not make any changes to the design of the device.
⚫
Do not submerge it under water.
⚫
Before using the device for the first time, it must be unpacked, removed from all packaging
materials and protective films and washed thoroughly in accordance with the cleaning
instructions below.
⚫
Do not clean the device while it is connected to a power supply.
⚫
The equipment must be earthed.
2. Installation and operation
2.1 The boiler must be installed somewhere with sufficient air circulation, with a humidity of no
more than 85%.
2.2 Before using the device, the inside of the tank must be cleaned with non-abrasive cleaning
agents.
2.3 Place the device vertically on a flat surface.
2.4 Make sure the switch is in the Off position. Connect the dispenser to an earthed outlet.
2.5 Open the top cover and fill the tank with water before turning on the equipment.
2.6 Turn on the power, the indicator lights up, then set the controller to the desired temperature.
2.7 Regularly remove scale in the tank.
ATTENTION!
⚫
Technical work may be performed only if the power supply is turned off.
⚫
During operation, the body of the device becomes hot. Do not touch it!
3. Service and maintenance
3.1 Control water level in the tank, when the water level is low, add water before it evaporates
completely.
3.2 If the thermostat does not turn off automatically after the water has boiled, slowly turn the
temperature controller in the opposite direction until the thermostat turns off.
3.3 If the water boils for 3 minutes, disconnect the device from the power supply and perform a
test.
3.4 If there is any malfunction, do not disassemble the unit yourself. All maintenance works on
the device must only be carried out by an authorized service.
3.5 Do not pull the power cord with force, otherwise you could damage it.
6
INTRODUCTION