LG WB20GB Manual De Instalación página 7

5
How to fix anchors and screws
Please make sure that:
- Check the material of the wall and the thickness of
the finishing material.
- Use the enclosed anchors and screws on crack-free
concrete walls.
- Never install the product on a wood stud,
plasterboard or wall made of paper or medium-
density fiberboard (MDF). When it is necessary to
install the product on such wall, anchor screws must
be fastened to retaining walls (concrete) inside the
finishing material, and if there are no retaining walls,
anchor screws must be fastened after a separate
hanger is installed.
- Other unspecified walls must be capable of
supporting pullout loads of over 70 kgf (686 N) and
shear loads of over 100 kgf (980 N) per fastener.
a
Anchors for fixing the wall mount
c
Screws for fixing the wall mount
e
- Use a Ø 8 mm drill bit and hammer (impact) drill for
concrete.
a. Drill holes in anchor locations with a drill bit of
Ø 8 mm to a depth of 80 mm to 100 mm.
b. Clean the drilled holes.
c. Insert the enclosed anchors for fixing the wall mount
into the holes. (Use a hammer when inserting
anchors.)
d. Push the wall mount support closely toward the wall
to match the hole locations.
e. Tighten screws for fixing the wall mount to the
holes. At this time, tighten the screws with the
torque more than 45 kgf/cm to 60 kgf/cm.
1
3
5
7
1 ~ 4
5 ~ 8
b
d
6
8
2
4
7