Unpacking; Commissioning; Connecting The Ph-Probe; Replacing Extension Cable And Temperature Sensor - IKA IKATRON ETS-D6 Advertencias De Seguridad

It is not possible to carry out pH measurements in metal containers.
The ETS-D6 is not suitable for diagnostic measurements for medi-
cal purposes.
• Range of use
- Laboratories
- Pharmacies
The protection for the user is not ensured no more, if the equip-
ment with accessories is operated, which are supplied or are not
recommended not by the manufacturer or if the equipment in not
correct use is operated against the manufacturer default.

Unpacking

• Unpacking
- Please unpack the device carefully
- In the case of any damage a detailed report must be set imme-
diately (post, rail or forwarder)
• Content of package
- ETS-D6
- Operating instructions

Commissioning

Plug the instrument into the contact thermometer jack on the
heating magnetic stirrer or heating device , e.g.
IKA: RCT basic, IKA RET basic, RH basic KT/C,
RH digital KT/C, HCT basic
Heidolph: MR3001K, MR3002
VWR: VMS-D, VWR VMS-A
H+P Variomag
18
- Schools
Please observe all safety instructions in this respect.
Connecting a "Corning" magnetic stirrer:
Turn the rotary "heat" dial on the magnetic agitator to the "O"
(off) position. Next, connect the ETS-D6 to the magnetic agita-
tor using the AD-C1 adapter provided.
Please observe all safety instructions in this respect.
¢ The device will be activated when the magnetic agitator is swit-
ched on.
If the supply voltage at the contact thermometer connector is not
between 8 Vdc and 16 Vdc then it will be necessary to power the
device using the H 52 power supply set (H 50 double connector
adapter and H 51 plug-in power supply unit). The power supply
and/or double connector adapter will provide the necessary supp-
ly voltage for the device. An automatic self-test will be performed
when the device is activated. An introductory screen will be shown
on the LCD display, see fig. 5.

Connecting the pH-probe

Connect the BNC-connector for the pH-probe to the BNC-
socket on the rear of the unit and lock in place using the bayo-
net fitting, see fig. 3.
Replacing extension cable and
temperature sensor
Pull the sensor and protective cap downwards, see fig. 4
¢The plastic snap fastener is released
Push the sensor or extension cable and protective cap over
the fitting on the instrument
¢ The connection is re-established
¢ LCD display see fig. 28
012007