Battery Charger; Safe Lifting - Grabo NEMO Manual Del Usuario

Battery charger

Charging output voltage
Charging output current
Charging input
Rated power
Operating temperature
Storage temperature
Working conditions
NEMO GRABO® lifting capacity
NOTICE: The Nemo GRABO® was tested up to 240 kg (530 lbs) at maximum lifting force under
ideal conditions. However, this figure is the breaking point under optimal lab testing conditions
and must never be reached in real-world applications!
Local regulations require different safety margins to be used and the official tool Working Load
Limit (WLL) is set to 120 kg (265 lbs) based on a 2:1 ratio on a non-porous surface. The Working
Load Limit of 120 kg (265 lbs) is one-half of the tested maximum lifting force under ideal
conditions (240 kg/530 lbs) and should be adhered to when working in countries where the
2:1 safety margin applies, regardless of the fact that the chart below shows a maximum lifting
force of 170 kg (375 lbs). In no case should the Nemo GRABO® be used to lift more than 170 kg
(375 lbs). Use the chart below to estimate safe lifting values:
Vertical lifting of non-porous materials (-0.8 bar)

SAFE LIFTING

0 (kg)
0 (lbs)
WLL: 120 kg (265 lbs) on non-porous surfaces
IMPORTANT: The lifting force is highly dependent on the lifted surface and factors such as
temperature, altitude (ambient pressure), and other factors.
Always check the pressure displayed on the Nemo GRABO® Pressure gauge Ⓖ and do not rely
solely on the estimated maximum lifting forces chart when lifting different materials since
different factors related to your specific application may reduce lifting capabilities of the tool.
16.8 V rated; 8 - 12 V under load
200 - 400 mA under load, 1.4 A max
100 - 240 V AC; 50/60 Hz; 1.5 A max.
23.52 W
0 °C ... +40 °C/+32 °F ... +105 °F
-20 °C ... +85 °C/-4 °F to +185 °F
Indoor use only; not waterproof (IP0)
CAUTION
120 (kg) 170 (kg)
265 (lbs) 375 (lbs)
NEMO GRABO | Operator's manual
DANGER!
11