Quantum ELM4L Guia De Inicio Rapido página 2

page 2
To maintain wet location rating, these accessories must be surface mounted with junction box using the supplied gaskets, as
described below.
Remove the round center knockout,
1
two small off-center knockouts, and
the desired pair of keyhole junction
box knockouts from the lighting unit
.
mounting plate
Unit Mounting plate
Install the accessory mounting plate
4
to the junction box and wall. NOTE:
two keyhole knockouts are included
in the accessory mounting plate for
additional security if needed. If these
keyholes are used, apply the
supplied extra gaskets as shown.
Two keyhole
knockouts
Factory-installed main gasket
INSTALLATION and WIRING
Use two supplied screws to attach the
2
unit mounting plate to the accessory
mounting plate.
Accessory
Mounting plate
Attach the unit front housing onto the
5
mounting plate.
Extra gaskets
LIFE SAFETY SOLUTIONS
TEL: 800-334-8694 Fax: 770-981-8141
Supplied screws
Housing
www.lithonia.com
Route the input leads through the
3
center openings and make
connections according to the lighting
unit installation instructions.
Make certain the gasket is properly in
6
place in the accessory cover, and
secure the cover to the mounting plate
with the ten remaining supplied screws.
Maximum screw torques are:
WPVS SML: 6.0 inch-lbs.
WPVS LRG: 10.0 inch-lbs.
Screws
Part # 912-00029-001
© Acuity Brands Lighting, Inc. 2017
Rev. A, 0/2017
All Rights Reserved.