Publicidad
Idiomas disponibles
Idiomas disponibles
Operate the appliance only with dry hands.
N
If the power supply cord is damaged during
N
use, disconnect the appliance from the power
supply immediately. Do not touch the power
supply cord before disconnecting from the
power supply.
Disconnect the appliance from the power
N
supply when not in use, before fitting or
removing parts and before cleaning.
Safety of others
Do not allow children or any person unfamiliar
N
with these instructions to use the appliance.
Do not allow children or animals to come near
N
the work area or to touch the appliance or power
supply cord. Close supervision is necessary
when the appliance is used near children.
After use
Remove the plug from the socket before
N
leaving the appliance unattended and before
changing, cleaning or inspecting any parts of
the appliance.
When not in use, the appliance should be stored
N
in a dry place. Children should not have access
to stored appliances.
Inspection and repairs
Before use, check the appliance for damaged
N
or defective parts. Check for breakage of parts,
damage to switches and any other conditions
that may affect its operation.
Do not use the appliance if any part is damaged
N
or defective.
Have any damaged or defective parts repaired
N
or replaced by an authorised repair agent.
Before use, check the power supply cord for
N
signs of damage, ageing and wear.
Do not use the appliance if the power supply
N
cord or mains plug is damaged or defective.
If the power supply cord or mains plug is
N
damaged or defective it must be repaired by
an authorised repair agent in order to avoid a
hazard. Do not cut the power supply cord and
do not attempt to repair it yourself.
Never attempt to remove or replace any parts
N
other than those specified in this manual.
ELECTRICAL SAFETY
Before use, check that the mains voltage
N
corresponds to the voltage on the rating plate.
This appliance is double insulated in
accordance with EN 60335; therefore no
earth wire is required.
To avoid the risk of electric shock, do not
immerse the cord, plug or motor unit in
water or other liquid.
ASSEMBLY
Before assembly, make sure that the
appliance is unplugged.
Place the chopper blade (5) on the pin (6).
N
Put the ingredients in the bowl (3). Use the
N
markings on the bowl to measure the correct
amounts.
Place the lid (4) on the bowl and make sure it
N
clicks into place. The top end of the shaft
should protrude through the hole in the lid.
Place the motor unit (2) on the bowl.
N
USE
Switching on and off
Plug in the appliance.
N
Set the speed control switch (1) to the desired
N
cutting speed.
Press down on the motor unit (2) to switch the
N
appliance on.
To switch off, release the motor unit.
N
Do not operate the appliance continuously
for more than 1 minute. After operating
the appliance continuously for 1 minute,
let it cool down for at least 3 minutes
before operating it again.
After use
Take the motor unit off the bowl.
N
Remove the lid from the bowl, by depressing
N
the two small ribs (7) on the lid.
Carefully remove the blade from the bowl.
N
Take out the chopped ingredients from the bowl.
N
E N G L I S H
5
Publicidad
