• 4.1
Safeguards
Here are some main rules to be followed in order to ensure a correct installation inside houses.
Installation must foresee, upstream the central unit, a safety bipolar switch.
• 4.2
Area of installation
Installation of a central vacuum unit presumes the existence of an aspiration pipe network, installed by qualified
staff that should also have spotted the best location for the central unit fixation template.
In case this was not carried out yet, following are some suggestions for a correct installation.
• If the central suction system has to be installed in multi-storey buildings, the suction unit must be located
at the lowest level of the building.
• Install it in rooms (balconies, storeroom, etc...) that are protected from humidity and high sudden
changes of temperature.
• If possibile, in the outside installations it's better to choose some areas that are less exposed to sunlight.
• Chose a space far from heat sources (burners or radiators).
• Provide spaces for the unit air flow entry and exit.
Foresee the air exhausting point outside the house, in a position that would not cause damage or nuisance to
other buildings.
• 4.3
Installation spaces
Around the unit, we suggest to leave a minimum free space as indicated in the picture, in order to make
easy the maintenance interventios, or repair, or dust collection bag change and, in the meanwhile, to
favour a right air circulation for the motor cooling.
For any question do not hesitate to contact the Manufacturer Technical Assistance Service.
1 m
400
• 4.4
Installation typologies
• Direct frontal air discharge (without pipes net)
• Carried air discharge (with pipes net)
• 4.5
Installation with direct frontal air discharge (without pipes net)
See illustrative page attached with the handbook
• 4.6
Installation with carried air discharge (with pipes net)
See illustrative page attached with the handbook
4 - INSTALLATION
- ATTENTION -
THE FOLLOWING OPERATIONS MUST BE
CARRIED OUT BY QUALIFIED STAFF
100
9
100
Wolly2 09/09-V00