Connect The Water Supply; Operation; Maintenance - Kärcher DS 2 Manual De Instrucciones

Nozzle colour
no nozzle
grey
black
beige
red
white
blue
light brown
green
orange
brown
yellow
turquoise
purple
pink
 Slide the nozzle insert all the way into
the detergent input.
 Slide the weight onto the detergent suc-
tion hose.
 Place the detergent suction hose onto
the foot valve.
 Hang the detergent suction hose with
the foot valve into the detergent con-
tainer.
 Slide the other end of the detergent
suction hose onto the detergent input (if
necessary, shorten the hose before-
hand).
 Slide the detergent hose with the fload-
ing gate ring at the top of the hose onto
the detergent solution output.
25% 3:1
22% 3,5:1
20% 4:1
11% 8:1
7% 14:1
5% 20:1
4% 24:1
3% 30:1
2% 45:1
1,7% 56:1
1,5% 64:1
1% 90:1
0,8% 128:1
0,5% 180:1
0,3% 350:1
NOTICE
Do not move the water floading ring from its
position.
 Slide the hook onto the bottom end of
the detergent solution hose.

Connect the water supply

 Connect the water feedhose to the wa-
ter inlet.
Feedhose inner diameter at least 13 mm.
Threaded fitting 3/4" BSPT.
Water pressure to at least 0.17 MPa
(1.7 bar).
 Hang the front of the casing into the rear
of the casing and lock at top.
 Open the water supply.
 Prime the appliance by briefly pressing
the button.
 Insert the hose for the detergent solu-
tion into the tank of the cleaning appli-
ance or into a container.
 Press the operating button and hold it
until the tank or the container is filled.
NOTICE
The button can be set so that it locks when
activated and must be pulled out to stop the
output of detergent solution. This modifica-
tion cannot be undone. For this, bend the
two ribs on the bottom of the button toward
the inside.

Maintenance

 Check the foot valve regularly for depos-
its. Remove the deposits with clear water.
– 3
EN

Operation

9