Care Instructions; Maintenance Instructions - ABLE2 Rigid Walker Frame Instrucciones De Montaje

ASSEMBLY INSTRUCTIONS
Please inspect all parts carefully for cracks/breaks prior to use.
STEP 1
Leg Tubing
Attach the 2 leg tubings onto the front
main frame, ensure the buttons protrude
completely and the 2 leg tubings are set
at the same height. (picture 1)
STEP 2
Attach the 2 leg tubings onto the rear
main frame, ensure the buttons protrude
completely and the 2 leg tubings are set
at the same height. (picture 2)
STEP 3
Assemble the front main frame and the rear
main frame using the round Philip's head
screw (M5x35mm) and arch washer.
Ensure the screws are tight. ( picture 3)
Arch washer & Philip's
head screw M5x35
STEP 4
Set the U connection tubing to the main
frame as shown on the pictures, use the
M5 screw and washer to lock up the
joints. (picture 4+5+6).
Picture 4
Philip's head screw
Aids to daily living
Front Main Frame
Rear Main Frame
Leg Tubing
Arch washer
Dimensions
& Philip's head
Height adjustable from 81 – 91.5 cm
screw M5x35
Width front: 45.7 cm
Width rear: 66 cm
Depth: 54.6 cm
Diameter aluminium frame: 25 mm
Arch washer
Picture 1
Picture 2
• When adjusting the height of the leg extension, make sure that each is set into the same height adjustment hole and that the
walker is level. Snap buttons must fully protrude through the adjustment hole of each leg extension to ensure a positive lock.
• Electric or pneumatic screwdriver is not suggested to use.
• Persons with severe disabilities or persons who are unable to walk without an aide should not attempt to use this product
Picture 3
without assistance.
USER INSTRUCTIONS
This walker is designed to help you balance or unload weight from your lower extremities while you walk.
To adjust handle height: stand up straight with arms at your side. Adjust the legs so the handgrips are level with the bend of the wrist.
Elbows should be slightly bend when in use, to offer control and more stability.
Make sure that the legs of the walker are level to the ground. Place the walker a comfortable distance in front of you. Using your arms for
support, walk up into the frame of the walker. Do not step up completely against the front bar of the walker. This could throw you off balance.
Picture 5 Repeat this process to continue walking.
U connection
When turning, take small steps so you won't lose your balance.
tubing
When sitting, back up all the way to the surface you are going to sit on until your legs touch the seating surface. Reach back with one hand to
the seating surface to steady yourself as you sit. When rising from a seated position, push from the seating surface to rise, then place hands on
Main frame
the grips of the walker.
Arch washer

MAINTENANCE INSTRUCTIONS

& Philip's head
Before use, check to make sure that the rubber tips are not ripped, worn, or missing. Replace if necessary before using.
screw M5x50

CARE INSTRUCTIONS

Clean with mild cleanser and water; dry thoroughly.
Blind Nut
(pre-installed in tubing)
Round
Blind
Philip's
Nut
head screw
(every screw must have a washer before
(M5x35)
Internal
Thread
Nut
Blind
Nut
Round
Thread nut
Philip's head
(located inside
screw (M5x50)
tube)
Maximum user weight 120 kg.
Picture 6
Arch washer
tightening)
120 kg