Operations And Performance - Toshiba RAV-SM2244DTP-E Manual Del Usuario

■
Confi rmation and check
When a problem occurred in the air conditioner, check
code and indoor UNIT No. appear on the display part
of the remote controller.
The check code is only displayed during the operation.
If the display disappears, operate the air conditioner
according to the following "Confirmation of check code
log" for confirmation.
check code Indoor UNIT No. in which
a problem occurred
■
Confi rmation of check code log
When a problem occurred on the air conditioner, the
check code log can be confirmed with the following
procedure. (The check code log is stored in memory
up to 4 check codes.) The log can be confirmed from
both operating status and stop status.
2
3
1
1
Push and buttons simultaneously for
4 seconds or more, the following display
appears.
If is displayed, the mode enters in the check
code log mode.
• [01: Order of check code log] is displayed in
CODE No.
• [Check code] is displayed in CHECK.
• [Indoor unit address in which a problem
occurred] is displayed in Unit No..
85-EN
1117880601_EN.indd 44 1117880601_EN.indd 44
2
Every pushing of button used to set
temperature, the check code log stored in
memory is displayed in order.
The numbers in CODE No. indicate CODE No.
[01] (latest) → [04] (oldest).
REQUIREMENT
Do not push button because all the check code log
of the indoor unit will be deleted.
3
After confirmation, push button to return to
the usual display.
9

Operations and performance

▼ Check before running
• Check whether the earth wire is cut or disconnected.
• Check whether the air filter is installed.
• Turn on the circuit breaker 12 hours or more before
starting operation.
▼ 3 minutes protection function
3-minutes protection function prevents the air
conditioner from starting for initial 3 minutes after the
main power switch / circuit breaker is turned on for
restarting the air conditioner.
▼ Power failure
Power failure during operation will stop the unit
completely.
• To restart the operation, push the ON / OFF button
on the remote controller.
• Lightning or a wireless car telephone operating
nearby may cause the unit to malfunction. Turn off
the main power switch or circuit breaker and then
turn them on again. Push the ON / OFF button on the
remote controller to restart.
▼ Defrosting operation
If the outdoor unit is frosted during the heating
operation, defrosting starts automatically (for
approximately 2 to 10 minutes) to maintain the heating
capacity.
• The fans in both indoor and outdoor units will stop
during the defrosting operation.
• During the defrosting operation, the defrosted water
will be drained from the bottom plate of the outdoor
unit.
▼ Heating capacity
In the heating operation, the heat is absorbed from
the outside and brought into the room. This way of
heating is called heat pump system. When the outside
temperature is too low, it is recommended to use
another heating apparatus in combination with the air
conditioner.
▼ Air conditioner operating conditions
For proper performance, operate the air conditioner under the following temperature conditions
Outdoor temperature
Room temperature
Cooling operation
Room relative humidity – less than 80 %. If the air conditioner operates in
[CAUTION]
excess of this figure, the surface of the air conditioner may cause dewing.
Outdoor temperature
Heating operation
Room temperature
If air conditioner is used outside of the above conditions, safety protection may work.
– 44 –
▼ Protective device
• Stops operation when the air-conditioner is
overloaded.
• If the protective device is activated, the unit stops
running, and the operation indicator and check
indicator on the remote controller blink.
▼ If the protective device is activated
• Turn off the circuit breaker and perform a checkup.
Continued running may cause a malfunction.
• Check whether the air filter is installed. If not, the
heat exchanger may be clogged with dust and water
leakage may occur.
▼ During cooling
• The air intake or discharge of the outdoor unit is
clogged.
• Strong wind continuously blows against the outlet of
the outdoor unit.
▼ During heating
• The air filter is clogged with a large amount of dust.
• The air intake or discharge of the indoor unit is
clogged.
▼ Do not turn off the circuit breaker
• During the air-conditioning season, leave the circuit
breaker turned on, and use the ON / OFF key on the
remote controller.
▼ Attention to snowfall and freeze on the outdoor
unit
• In snowy areas, the air intake and air discharge
of the outdoor unit are often covered with snow or
frozen up. If snow or freeze on the outdoor unit is
left as it is, it may cause machine failure or poor
warming.
• In cold areas, pay attention to the drain hose so that
it perfectly drains water without water remaining
inside for freeze prevention. If water freezes in the
drain hose or inside the outdoor unit, it may cause
machine failure or poor warming.
: –15 °C to 46 °C (Dry bulb temp.)
: 21 °C to 32 °C (Dry bulb temp.), 15 °C to 24 °C (Wet bulb temp.)
: –20 °C to 15 °C (Wet bulb temp.)
: 15 °C to 28 °C (Dry bulb temp.)
86-EN
3/15/2559 BE 08:50 3/15/2559 BE 08:50