Pc Input Typical Display Modes; Av And Hdmi Signal Compatibility - Hitachi 40HE4000 Manual De Instrucciones

No picture
• TV is not receiving any signal. Make sure the correct
source has been selected.
• Is the antenna connected properly?
• Is the antenna cable damaged?
• Are suitable plugs used to connect the antenna?
• If you are in doubt, consult your dealer.
No sound
• Check if the TV sound is muted. Press the Mute
button or increase the volume to check.
• Sound may be coming from only one speaker. Check
the balance settings from Sound menu.
Remote control - no operation
• The batteries may be exhausted. Replace the
batteries.
• The batteries maybe inserted incorrectly. Refer to
the section "Inserting the Batteries into the Remote".
No signal on an input source
• It is possible that no device is connected.
• Check the AV cables and connections from your
device.
• Check the device is switched on.
Recording unavailable
To record a programme, you should first correctly
connect a USB storage device to your TV, while the
TV is switched off. You should then switch on the TV to
enable recording feature. If you cannot record, check
the storage device is correctly formatted and there is
sufficient space.
USB is too slow
If a "USB disk writing speed too slow to record"
message is displayed on the screen while starting a
recording, try restarting the recording. If you still get
the same error, it is possible that your USB storage
device does not meet the speed requirements. Try
using a different USB storage device.

PC Input Typical Display Modes

The following table is an illustration of some of the
typical video display modes. Your TV may not support
all resolutions.
Index Resolution
1 640x480
2
640x480
3
800x600
4 800x600
5 800x600
6 800x600
7 1024x768
Frequency
60Hz
75Hz
56Hz
60Hz
72Hz
75Hz
60Hz
English - 28 -
8 1024x768
9 1024x768
10 1152x864
11 1280x768
12 1360x768
13
1280x960
14
1280x1024
15 1280x1024
16 1400x1050
17 1440x900
18 1440x900
19 1920x1080

AV and HDMI Signal Compatibility

Source Supported Signals
PAL
SECAM
Back AV
NTSC4.43
NTSC3.58
480i, 480p
576i, 576p
YPbPr
720p
1080i
480i, 480p
576i, 576p
720p
1080i
HDMI
1080p
(X: Not Available, O: Available)
In some cases a signal on the TV may not be displayed
properly. The problem may be an inconsistency with
standards from the source equipment (DVD, Set-top
box, etc. ). If you do experience such a problem please
contact your dealer and also the manufacturer of the
source equipment.
70Hz
75Hz
75Hz
60Hz
60Hz
60Hz
60Hz
75Hz
60Hz
60Hz
75Hz
60Hz
Available
O
O
O
O
60Hz O
50Hz O
50Hz,60Hz O
50Hz,60Hz O
60Hz O
50Hz O
50Hz,60Hz O
50Hz,60Hz O
24Hz, 25Hz,
30Hz, 50Hz, O
60Hz