General Features; General Description - Bentley Wave Serie Guia De Inicio Rapido

! ! ! ! ! Do not touch the PCB for at least 2 minutes after remov-
ing the power supply: 250 V_
the PCB circuitry of this device.
! ! ! ! ! This device is designed to work with Nickel-Cadmium
batteries. When disposing of used batteries, abide by
the Local laws in force.
! ! ! ! !
The self-powered versions (Wave/WSB and Wave/WB)
must be powered for at least 24 hours to ensure that the
battery is fully charged.

GENERAL FEATURES

ˆ
Available with or without back-up battery, with or without
Strobe
ˆ
2 selectable sound types
ˆ
Tamper detection (tamper and snatch tamper)
ˆ
Universal Wall mount bracket

GENERAL DESCRIPTION

The Wave HornStrobe is an Audible-Visual Alarm signalling
device for Security Systems.
It is available in four versions, as per the following table.
Version
Wave/WSB
Wave/WB
Wave/WS
Wave/W
All versions have piezoelectric transducers for audible signal-
ling, whereas only the Wave/WSB and Wave/WS versions are
fitted with Strobes for visual signalling.
The Wave/WSB and Wave/WB versions are fitted with 7.2 V –
300 mA batteries (art. CB7203) for back-up power during black-
out.
All versions have tamper terminals that signal the removal of
the Lid and the snatch.
INSTALLATION GUIDELINES
Carefully work through the following steps (see Figure 1).
This HornStrobe is suitable for indoor use only.
1. Remove the Logo Insert 5.
2. Remove the screw 4.
3. Pull the Lid 3 upwards and away from the backplate.
4. Remove the Lens cover 2.
5. Using a screwdriver or similar tool, push down on the lock-
ing tab 9 and push the Wall bracket 12 away from the
Backplate 10.
6. Pull the connection wires through the cable entry 13.
7. Using anchor screws, secure the Wall bracket 12 to the wall
or to the outlet box.
Snatch Tamper functions ONLY when a screw is properly
fixed in the hole 14 (figure.1).
! ! ! ! ! Be careful to avoid conduits and plumbing when drill-
ing.
8. Pull the connection wires through the cable entry 11.
9. Slide the Backplate 10 downwards onto the Wall bracket
12 until it snaps closed.
10. Select the required sound type, as per the instructions in
the relevant section.
11. Complete the connections on the terminal board 7, as per
the instructions in the relevant section.
_ may still be present across _ _
_
Strobe Back-up Battery
YES YES
no YES
YES no
no no
G G ENGLISH G
G G
12. Replace the Lens cover 2.
13. For Wave/WSB and Wave/WB only: locate the battery 6,
as per Figure 1, then connect it to the input J5.
! ! ! ! ! For Wave/WSB and Wave/WB only: before connecting
the battery, ensure that: the Positive Voltage (13.8 V) is on
terminal +B; the Positive Voltage (13.8 V) is on terminal
+N or jumper J3 is connected; Ground is present on –A.
14. Snap the top of the Lid 3 onto the Backplate 10, then push
the bottom part onto the backplate posts.
15. Replace the Closure screw 4.
16. Replace the Logo Insert 5.
SELECTING THE SOUND TYPE
Two different sounds are selectable via jumper J15:
J15 SOUND TYPE
Up and Down scale modulation (Default)
Bitone