Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
ALSET-2000 WIRELESS SECURITY SYSTEM
EN
5. Pair the ALMST to the ALSIR
Put the ALSIR in learn mode (see step 3). After putting the ALSIR in learn mode send a pair-signal by
pressing the SET button with a sharp object next to the battery slot of the magnetic sensor. The LED
indicator of the ALMST will flash 5x to confirm that the pairing has been done successfully.
6. Open the ALMDT and place batteries
Open the battery slot on the back side of the motion sensor by pushing the pull-tab down and
removing the battery cover. Insert two AA
1,5V
Alkaline batteries as shown above (not included).
Observe the correct polarity of the batteries place plus and minus on the correct side. Close the
battery slot.
7. Pair the ALMDT to the ALSIR
Put the ALSIR in learn mode (see step 3). After putting the ALSIR in learn mode send a pair-signal by
pressing the SET button with a sharp object on the back of the sensor. The LED indicator of the ALMDT
will flash 5x to confirm that the pairing has been done successfully.
8. Open the ALKCT and place battery
Open the battery slot at the back of the ALKCT by sliding it down.
Place the included 3V CR2477 battery
and close the battery slot.
For more information on replacing and purchasing new batteries visit trust.
com/71115
9. Pair the ALKCT to the ALSIR
1. Put the ALSIR in learn mode (see step 3). Put the ALKCT in pair-mode by first pressing the ON and
OFF button simultaneously for 4 sec (untill the LED of the ALKCT starts blinking).
2. Give a short press on the ON button to pair with the Siren. The LED indicator of the ALKCT will be
flashing 5x to confirm that the pairing has been done successfully.
2
Publicidad
Tabla de contenido
