Hickory Night Latch Manual De Instrucciones

INSTRUCTIONS
1. At desired height bore the hole for the cylinder 1-1/4" diameter,
with center at a distance of 2-3/8" from edge of door.
2. Insert cylinder and ring from the outside of door and place back
plate on inside of door. Connect back plate to cylinder with two
connecting screws. Cut screws to proper length relative to door
thickness.
3. Cut off connecting bar so that it projects 3/8" beyond inside of
door.
1105
SATISFACTION GUARANTEED
(See website for details http://www.hickoryhardware.com/warranty)
HICKORY HARDWARE, INC.
©
3438 Briley Park Blvd • Nashville, TN 37269
Made to Hickory Hardware's specifications in China
5.625x2.375_IS.indd 1
Night Latch
4. Place lock on door so that connecting bar enters slot. Mark
holes. Remove lock and drill 1/8" pilot holes. Attach lock to
door by inserting screws through lock into door.
5. Place strike plate on door jamb. Mark holes. Remove strike
plate and drill 1/8" pilot holes.
6. As needed, use chisel to cut door jamb so that strike is flush
with door jamb.
2/19/07 9:51:14 AM