Style selections LWXG48VM Instrucciones De Montaje página 3

ASSEMBLY INSTRUCTIONS
Step 7:
Note: The adjustable shelf is pre-installed for shipping.
If the shelf position is not to your liking, you will need to
reposition the shelf by following the steps below:
a. Look under the shelf, and locate the wood screws
holding the shelf to the shelf supports.
b. Remove the wood screws from each shelf support
with a Phillips screwdriver (not included).
c. Remove the adjustable shelf from the vanity (B).
d. Remove the shelf supports from the vanity (B) and
re-position them in the desired location. Make sure
you place the shelf supports in the same level so
the shelf is not tilted.
e. Place the adjustable shelf back onto the shelf supports.
f. Using the Phillips screwdriver, reinstall the wood screws
through the shelf supports and into the shelf.
Step 8:
If the door preassembled to vanity base (B) require
adjustment, follow the below options as needed:
To adjust door up or down, loosen screws (a), adjust door
and tighten screws.
To adjust door left and right, turn screw (b) in or out.
To adjust door in and out, loosen screw (c), adjust door
and retighten screw.
Step 9:
Removing the Drawer:
1. Unload the contents from the drawer.
2. Slide out the drawer as far as it will go.
3. Press the lever down on the right-hand track and lift the
lever up on the left track to release the drawer. Pull the
drawer out the rest of the way.
Replacing the Drawer:
1. Align the drawer guides with the receiving glides.
2. Hold the receiving glides firmly and insert the drawer guide.
NOTE: It is normal for the drawer to close tightly the first
time after it has been removed.
3. Push the drawer in completely.
v
7
B
v
8
B
v
9
5
ASSEMBLY INSTRUCTIONS
Step 10:
Use a stud finder (not included) to find the wood stud at
the desired installation site and mark area with a pencil
(not included). Then, using the mounting brackets
preassembled on mirror (D) as a guide, mark the screw
locations of the mounting area.
Step 11:
Drill a 1/8 in. diameter pilot hole at marked location on the
stud; Drill a 3/8 in. diameter pilot hole at least 2 1/2 in. deep
at marked location on solid wall, push wall anchor (sold
separately) into the hole until it is flush with the wall, then
insert M4 x 63 mm wood screws (BB) into holes. Do not
b insert the screws all the way. Leave the screws 1/4 in. from
a
the wall.
c
Hardware Used
BB
M4 x 63 mm Wood Screw
Step 12:
Carefully hang mirror (D), ensuring it is level and stable
on the hardware.
v
1 0
v
1 1
Wooden Stud
wall anchor
x 2
(not included)
BB
12
D
6
BB