Stadler Form Albert Manual De Instrucciones página 6

before switching it back on. The water tank must be emptied every time
before transport.
• The dehumidifier must always be operated according to this instruction
manual. Non-observance of these instructions can lead to injuries, a fire,
electric shock or faults in the appliance.
• The dehumidifier is designed for private use indoors and is not intended
for commercial use.
• If the power cord of the dehumidifier is damaged, it must be replaced by
the manufacturer or a repair shop authorized by the manufacturer or by
similarly qualified persons in order to prevent damage.
• Do not use the dehumidifier if it is faulty or could show signs of damage,
or if it is not functioning correctly. Disconnect the plug from the power
socket.
• Repairs to electrical appliances must only be carried out by a qualified
electrical technician. If improper repairs are carried out, the warranty
lapses and all liability is refused.
• The appliance shall be installed in accordance with national wiring regu-
lations.
• If the unit is not used for a longer period of time, switch it off and unplug
it, empty the water tank, pack it after 48 hours while the inside compo-
nents are dry, keep it then in a dry and ventilated place. When storing
the unit, please make sure it stands in an upright position. Never put it
upside down.
Setup / operation
1. Place Albert on a flat surface in the desired area. Plug the power cable
(16) into an electric socket.
2. Press the on/off switch (3) to turn on the dehumidifier.
3. You can select the speed of the fan in the dehumidifier by pushing
the speed level selector (5). There are 3 speed levels. If the speed is
higher, the dehumidifying performance also increases.
4. With the hygrostat (4) the desired humidity level can be set. Press on
the knob hygrostat (4) and change to desired humidity level with the
rotary control (10). Humidity levels between 30 and 80% or continuous
running (CO in display) can be selected. A humidity level not higher
than 60% is suggested in general. If the dehumidifier reached the se-
lected humidity it will turn off and after that check the humidity level
in constant intervals by turning on the fan for a short time.
5. With the timer you can selecte precisely when Albert should be run-
ning. The timer can be activated by pressing the knob timer on/off
(6) and the LED will be lit. If you press the knob again the timer will
not be active and the LED will be off. To set the timer follow these
instructions:
6. Set the time: Press set (7) for 5 seconds and the symbol for hour is
shown blinking in the display, in addition the hours are blinking. Now
you can choose the correct hour with the rotary control (10). If the
hours are correct, press set (7) again and the minutes can be adjusted
the same way. To finish press set (7) again.
7. Set the timer: Press set (7) shortly and now you can set the timer when
the unit should turn on (timer on) and the timer when the unit should