Operation; Rcd Adapter - Steinbach BP-39WS-B Mini Manual Original

Operation

A damaged device or damaged accessories can lead to injuries.
- Check the device and the accessories (see the chapter on "Points
to check").
Reduced or blocked ventilation of the heat pump can lead to
insufficient removal of heat or moisture. This can cause mould to
form or overheating of the finned heat exchanger.
- Clean the grille in front of the fan blade and the fins of the heat
exchanger regularly and ensure that debris such as leaves or the
like do not enter the inner part of the heat exchanger.
- Ensure that the grille on the heat exchanger is never covered
over and air can flow freely through the device.

RCD adapter

The RCD adapter consists of an earth-contact plug and a residual current device. The
C
earth-contact plug must be connected to a suitable power socket with a protective earth
conductor. The residual current device disconnects the heat pump from the electricity as
soon as any unexpected currents which are hazardous for humans flow via the heat
pump (e.g. body contact via electrically conductive parts of the housing).
Testing the residual current device
1. Connect the RCD adapter
installation site.
2. Press the RESET button
The LED lights up. The heat pump is supplied with electricity and is in the Standby
11
mode.
3. Press the TEST button
The LED lights up. The heat pump is disconnected from the electricity and the
11
Display goes out.
14
4. Press the RESET button
CAUTION!
Risk of injury!
NOTE!
to the electrical supply that has been prepared at the
C
.
12
.
13
.
12
55