Remington MODSAW Manual De Instrucciones página 5

ASSEMBLY
Continued
5. Insert tab of sprocket cover into slot on unibody and
rotate sprocket cover onto guide bar bolt until
sprocket cover rests against guide bar (see Figure 5).
Adjusting Hole
Slot
Sprocket Cover Tab
Figure 5 - Installing Sprocket Cover
6. Place guide bar nut, removed in step 2, on guide
bar bolt.
IMPORTANT: Tighten guide bar nut finger tight only.
7. Turning chain tensioning screw, adjust position of ad-
justment block until it is aligned and inserted into the
round adjusting hole on guide bar (see Figures 5 and
6). Turning screw counterclockwise will move adjust-
ment block to rear of guide bar. Turning screw clock-
wise will move adjustment block to front of guide bar.
Figure 6 - Chain Tensioning Screw and Adjust-
ment Block Location
115038
p
S t e
1
Chain Tensioning
Screw
Adjustment Block
Guide Bar Bolt
S t e
2
Bushing
Guide Bar Nut
5
p
Continued
www.desatech.com