Uline H-1555-20 Guia De Inicio Rapido

π
13-16 STEP ROLLING
SAFETY LADDERS
20 AND 30" DEEP TOP STEP
TOOLS NEEDED
Step Ladder
Rubber Mallet
A. Side Handrail (1)
B. Side Handrail (1) Opposite
C. Rear Handrail Bar (2)
(shipped taped to handrail)
D. Stile (1)
E. Base Panel (1)
WARNING! Assembly of these types of ladders
can be inherently dangerous. Please take all
necessary precautions during the assembly
process. Always use a separate ladder to
finish assembly in high places. Never climb a
ladder that is not completely assembled. Do
not assemble or use a ladder with missing or
damaged parts. Use proper lifting mechanics
when assembling a ladder. Watch for overhead
electrical hazards and obstructions.
PAGE 1 OF 9
1-800-295-5510
uline.com
9/16" Wrench or Socket (2)
7/16" Wrench or Socket
Safety Glasses
PARTS
F. Back Panel (1)
G. Horizontal Brace (2)
ASSEMBLY
STEP 1: FRAME ASSEMBLY
1.
Pour le français, consulter les pages 7-9.
H. Vertical Brace (2)
I. Diagonal Brace (2)
J. Handrail Extension Panel (2)
Notched
Bushing (4)
Handrail Bracket (6)
(shipped attached to handrails)
NOTE: DO NOT tighten bolts until instructed to.
NOTE: Back panel (F) has both round and
slotted holes. The round holes are at the bottom,
and the slotted holes are at the top (L1).
Place the ladder stile (D) on the floor. Be sure to
assemble on a protective surface so the finish does
not get damaged. (See Figure 1)
Para Español, vea páginas 4-6.
Hardware Kit (1)
(misc. hardware included)
Extension Clamps
Set (4)
Gray Bushing (6)
0521 IH-1555-20