Adjust The Saw Carriage - yrco WS 440 HF Manual De Instrucciones

ASSEMBLING AND ADJUSTMENTS
Tighten screws with a 8 mm allen key. Repeat the previous
step.

Adjust the saw carriage

As the saw wears, after a number of hours working, it can be
a good idea to ensure that the saw sits firmly in the saw
carriage and rail. If not, the handle probably needs adjusting:
Loosen the two stop screws with a 3 mm allen key.
Turn the two excenter sleeves with a 8 mm allen key until the
shaft is tight and parallell to the saw unit.
Tighten the two stop screws with a 3 mm allen key.
12 –
English
Make sure the locking handle is properly adjusted by open
and close and see that the spring loaded lock is in locked
position.
Then secure the locked handle with the locking pin.