Recessing Of The Appliance With Static Condenser; Appliance Recessing With Ventilated Condenser - Vitrifrigo C25L Manual De Instrucciones

eventual contents. Once installation has been completed, check that the refrigerator
is not resting on a power cable. If the power cable is damaged, it must be replaced
immediately by someone from the technical service centre or by someone suitably
qualified, in order to avoid any risk.
Place the refrigerator away from heat sources ensuring that it has enough ventilation as
in the following installation examples.
Once the refrigerator has been positioned, wait at least one hour before switching it on.

Recessing of the appliance with static condenser

The dimensions of the front opening envisaged for recessing the appliance must respect
the dimensions of the refrigerator and, in order to guarantee stability, must allow for the
correct assembly of the fixing frame installed (see annex 1).
The recess must respect the minimum distances between the appliance and the
surrounding structure and it must have suitable ventilation openings communicating
directly with the free space in the room, in order to obtain correct air circulation by
means of the chimney effect, as indicated in annex 2 - figure 1.
The recess must ensure that no electrically live part of the appliance is directly accessible
(thermostat, control unit and fan), equipping them with appropriate grilles, just like the
ventilation openings.
The grilles must have openings with max. dimension of 5 mm.
The ventilation openings must have minimum dimensions of at least 75 mm in height
and not less than the dimension of the refrigerator in width if positioned above or below
the appliance (anx.2 - fig.1), or not less than 120mm in height and the dimension of the
refrigerator in width if positioned behind. (anx.2 - fig.1)
The minimum distances between the various parts of the appliance and the recess
structure must not be less than 75mm. (anx.2 - fig.1)
For recess situations in spaces where the minimum distance of 75mm is respected only
in the rear part of the appliance, make the ventilation openings on the same side
respecting the indications for the position, number and dimensions shown in fig.1.
For recess situations with the presence of shelves in contact with the upper and lower
parts of the appliance, make the ventilation openings above and below the appliance
or in the rear part as shown in fig.1.
In all the situations of the described ventilation openings, only the minimum distance of
75mm from the sides of the appliance may not be observed.

Appliance recessing with ventilated condenser

The size of the front opening to be prepared for recessing the appliance must respect the
dimensions of the refrigerator (see annex 1).
ENG 23