Important Safety Instructions - TLC TTW Serie Manual Del Usuario

Before installing and using your air conditioner, please read owner's manual carefully. Store this
manual in a safe place for future reference. Your safety and the safety of others is very important
to us. Please pay attention to all safety messages outlined in this owner's manual. Take proper
precautions to avoid unattended operations. Do not run air conditioner with outside protective
cover in place. This could result in mechanical damage to the air conditioner. Do not store or use
gasoline or other flammable vapors and liquids in the vicinity of this or any other appliance.
WARNING:
To reduce the risk of fire, electrical shock or injury when using your air conditioner,
The electrical ratings for your air conditioner are listed on the model and serial number label
located on the front right side of the unit (when facing the front).
To avoid the risk of property damage, personal injury, or fire, only use copper conductors.
LCDI or AFCI Power Cords - National Electric Code (NEC) now requires power cords that sense
current leakage and can open the electrical circuit to the unit on units rated at 250 volts or less. If
the unit does not operate, check the reset button located on or near the head of the power cord
as part of the normal troubleshooting procedure. Do not use the reset button as normal means of
You can register your appliance online by going to register.tcl.com
Be sure to retain your original sales receipt. A valid proof of purchase is required for all
Do not mix old and new batteries and do not mix alkaline, standard (carbon-zinc) or rechargeable
Model #___________________________________
You can locate your 20 digit serial number underneath the bar code (right hand side of the AC).
WARNING
Electrical Shock Hazard
Plug into a grounded 3
prong outlet.
Do not remove the
ground prong.
Do not use an adapter plug.
Do not use an extension cord.
Failure to follow these instructions
can result in death, fire, or
electrical shock
Do not use a splitter, daisy chain,
or overload an outlet. Doing this
can cause electrical fires and/or
electrocution. Do not share the
outlet being used by the unit with
another appliance or
electronic device.

IMPORTANT SAFETY INSTRUCTIONS

Do not place objects or liquids on top of the unit.
Do not allow children to operate this device.
follow the following basic precautions:
ELECTRICAL REQUIREMENTS
turning the unit on and off.
REGISTER YOUR APPLIANCE
warranty claims.
BATTERY WARNING STATEMENT
(ni-cad, ni-mh, etc.) batteries
Document your model and serial numbers here:
Specific electrical requirements are shown in the diagram below.
Follow the requirements below for the type of plug on the
Wiring Requirements
• (15K) 115 Volts
(103 min – 127 max)
(18K – 24K) 230 Volts
(187 min – 253 max)
• (15K) 0-11 amps
(18K) 7.1 amps
(24K) 11.0 amps
(15K) 3.15 amp
time-delay fuse or
circuit breaker
(18K-24K) 3.15 amp
time-delay fuse or
circuit breaker
• Use on single outlet
circuit only on all sizes
Serial #______________________________
power supply cord.
Power Supply Cord
• H8T91, 8T3E1,
H8T9E1, 10T3E1,
H10T9E1,
12T3E1,
H12T9E1:
15K BTU
115V grounded
115 Volt
wall outlet
18K – 24K BTU
208/230 Volt
Power Requirements
• H8T9X,
H10T9X,
H12T9X:
230V grounded
wall outlet