stayer RO150E Manual De Instrucciones página 11

Product Specification
Eccentric Sander
Rated input power
No-load speed
Ø Oscillation excursion
Ø Sanding plate
Weight
Protection class
The specifications apply for the rated voltage of [U]
230/240 V ~ 50/60 Hz. - 110/120 V. ~ 60 Hz. For lower
voltages and with models for specific countries, the
specifications can vary.
Please refer to the article number on the nameplate of
your machine since the trade designation of individual
machines can vary.
Product Elements
The numbering of the machine elements refers to the
illustration of the machine on the graphic page.
1 Speed selector thumbwheel
2
On/off switch
Vacuuming adapter
3
Auxiliary Handle
4
Sanding sheet
5
Lock button
6
Sanding plate
7
Noise/Vibration Information
Measured values determined according to EN 60745.
Typically, the A-weighted sound pressure level of the
product is 81 dB(A).
Measuring inaccuracy K = 3 dB.
The noise level when working can exceed 85 dB(A).
Wear ear protection!
The typical hand-arm vibration is below 2.5 m/s.
RO150E
[W] 450
-1
[min ] 4000-13000
[mm] 2,4
[mm] 150
[kg] 2.4
/ II
2
ENGLISH
10
The vibration emission level given in
this information sheet has been
measured in accordance with a
standardized test given in EN 60745 and may be used
to compare one tool with another.
The vibration emission level will vary because of the
ways in which a power tool can be used and may in-
crease above the level given in this information sheet.
This could lead to a significant underestimate of expo-
sure when the tool is used regularly in such a way.
Note: To be accurate, an estimation of the level of ex-
posure to vibration experienced during a given period
of work should also take into account the times when
the tool is switched off and when it is running but not
actually doing the job. This may significantly reduce
the exposure level over the total working period.
Intended Use
The machine is intended for dry sanding of wood,
plastic, metal and filler material as well as painted sur-
faces.
Machines with electronic control are also suitable for
polishing.
For Your Safety
Read all instructions. Failure to fol-
low all instructions listed below may re-
sult in electric shock, fire and/or serious
injury.
SAVE THESE INSTRUCTIONS.
In addition, the general safety instructions either en-
closed or included in the middle of these operating
instructions must be observed.
Hold the machine firmly with both hands while
working and provide for secure footing. The
machine is more securely guided with both hands.
Secure the work piece. A work piece clamped
with clamping devices or in a vice is held more se-
curely than by hand.
Do not work with materials containing asbes-
tos. Asbestos is considered carcinogenic.
Take protective measures when dust can de-
velop during working that is harmful to one's
health, combustible or explosive. Example:
Some dusts are regarded as carcinogenic. Wear a
dust mask and work with dust/chip extraction
when connectable.
10