Urrea 6310 Manual De Usuario Y Garantía página 6

USAGE:
1. Begin torquing fastener using a pulling motion.
2. The display will track the applied torque.
3. Stop application of torque when half-second audible tone
is heard and GREEN LED illuminates, If RED LED illuminates,
preset torque value has been exceeded. When this occurs the
operator must loosen fastener and repeat torque application.
USE OF ADAPTERS, EXTENSIONS AND UNIVERSALS
Anytime an adapter, extension or universal is used with a torque wrench in such a way that the fastener distance is different that
the torque wrench square drive distance, an adjustment to the set torque is required to get proper fastener torque.
Fastener torque equals torque wrench square drive torque.
Wrench setting is equal to desired fastener torque.
Fastener torque equals torque wrench square drive torque.
Wrench setting is equal to desired fastener torque.
Fastener torque is greater than torque wrench square
drive torque. Calculated setting will be lower that desired
fastener torque.
6
NOTE: YELLOW LED will illuminate when 90% of desired
preset value has been achieved.
4. On release the PEAK (highest torque value applied)* will be
displayed, flashing for 10 seconds or until torque is reapplied.
* The PEAK torque reading will tell you if excess torque
has been applied. This feature can be used to improve you
wrenching technique for best accuracy.
Fastener torque is less than torque wrench square drive
torque. Calculated setting will be higher than desired
fastener torque.
When using a universal or wobble extension, do not
exceed more than 15 degrees of offset from perpendicular
drive. Do not use long extensions with the flex-drive.