Conformity Declaration - Ubbink Pool Filter 400 Manual De Instrucciones

1
Pool Filter 400 / 500 / 600 - Pool Filter Sets 400-4m
PROBLEM
Irregular operation
The product's throughput is low.
Water is leaking out of the filter opening.
The filter valve leaks at the end for the drain output
(WASTE).
The pump motor does not start
Water return is very weak (return inflow)
The pressure gauge indicates the pressure is too high
The pressure gauge indicates the pressure is too low.
2
Guarantee
We guarantee this product for two years against provable material and manufacturing faults, starting from the date of purchase. The original purchasing proof must be presented for
claims under this guarantee. The guarantee does not cover complaints caused by assembly and/or operating faults, insufficient care, frost damage, improper repair attempts, use of
force, third party faults, overload, mechanical damages or impact of foreign bodies. Also excluded from the guarantee are all complaints regarding damages to parts and/or problems,
which are due to wear. The warranty is void if the electrical cable and/or the plug are replaced, removed or damaged.
Correct disposal of this product
This symbol points out inside the EU that this product must not disposed via the domestic waste. Old devices contain valuable materials for recycling, which should
be passed on to recycling and not harm the environment or human health due to uncontrolled waste disposal. Please, dispose the old devices via suitable collecting
systems or send the device for disposal to the place you bought it from. This will then pass on the device to recycling.

Conformity declaration

The undersigned company UBBINK GARDEN BV declares in own responsibility that the swimming pool pumps Poolmax
requirements oft f f heEuropeanDirective2006/95EG
60335-241:2003+A1; EN 50366:2003+A1; ZEK 01.1-08/06.08 EN 55014-1:2006; EN 55014-2:1997+A1; EN 61000-3-2:2006; EN 61000-3-3:1995+A1+A2
CAUSE
Water level in skimmer is too low.
The filter is empty.
Due to prolonged use, the filter is dirty.
The filter is empty.
The surfaces between the valve and the filter are dirty.
The clamp is loose
Improper use of chemicals or use of unsuitable chemicals has
damaged the product's inner seals.
Due to improper use, the head valve is defective
(tightened too fast).
Not getting electricity
Defective motor
Check the filter pressure, the multi-port valve and the flexible line connection for signs of the problem's cause.
The filter is clogged.
Closed valve
The pump's preliminary filter basket is clogged.
The skimmer basket is clogged.
The pump turbine is clogged.
The swimming pool water level is too low.
Closed valve
Pump ran without water.
Air intake during suction
/ / (Lowvoltage)and2004/108/EG(EMV).Thefollowingharmonisedstandardshavebeenapplied:EN60335-1:2002+A1+A11+A12+A2+A13;EN
3 /h / 400-6 m³/h / 500-9 m³/h / 600-13 m³/h
SOLUTION
Fill the swimming pool and filter.
Fill the filter.
Activate the automatic cleaning mode.
Fill the filter.
Clean the multi-port valve, make proper connections and tighten
the hose clamps suitably.
Replace the top cover of the valve.
Avoid emptying chemical products in the preliminary filter basket
or the skimmer.
Replace the head valve and avoid excessive tightening.
Check electrical lines.
Contact your dealer.
Rinse the filter.
Open the valve.
Clean it.
Clean it.
Clean it.
Add water to the swimming pool.
Open the valve.
Fill the preliminary filter with water.
Check the tightness of the hydraulic connections.
TP 35 / TP 50 / TP 75 / TP 120 / TP 150 meet the
8