SNOWJOE AUTOJOE ATJ-CA100 Manual De Usuario página 6

•
Once the battery is fully charged, the three
bars will remain static at which point unplug
the USB-A to USB-C cable from the inflator.
NOTE: Timely recharging of the tool will help
prolong its battery life.
m
WARNING!
automatically turn off when the battery is fully
charged. Please take care not to leave the
inflator plugged in. Unplug the charging cables
when charging is complete.
IMPORTANT! Never allow the tool to become
fully discharged as this will degrade the battery
life over time.
m
WARNING!
overuse of the ON/OFF button can permanently
damage the lithium-ion battery.
•
During the charging procedure, the inflator
will feel slightly warm to the touch. This is
normal.
•
When no further use is planned for an
extended period of time, disconnect the
charging cable from the unit and the electrical
outlet/12V DC socket.
•
Do not use the device while charging.
Battery Charging Tips
To obtain the longest possible battery life, we
suggest the following:
•
Store and charge your inflator in a cool area.
Temperatures above or below normal room
temperature will shorten battery life.
•
Never store the inflator with the battery in
a discharged condition. Recharge the unit
immediately after it is discharged.
•
All batteries gradually lose their charge. The
higher the temperature is, the faster they lose
their charge. If you store your inflator for long
periods of time without using it, recharge the
battery every 6 months. This will extend its
battery life.
NOTE: The inflator has been shipped in a low
charge condition and should be fully charged
before use.
Operation
1. To turn on the inflator, long press the power
button until the LCD display illuminates
(Fig. 3).
NOTE: The LCD display will automatically turn
off when not in use for 150 seconds or more.
The chargers do not
Continued and excessive
Fig. 3
LCD
display
2. Press the mode button
4 different modes: ball, bicycle, motorcycle
and car (Fig. 4).
Fig. 4
Modes
+
–
3. The
and buttons allow you to manually
adjust the inflation pressure. This determines
the pressure at which the inflator will pump
up to. Press either the
increase or decrease pressure by increments
of 0.5 PSI, or long press to quickly cycle the
psi value up or down (Fig 5).
Fig. 5
PSI
volume
buttons
4. Once the desired PSI has been set, short
press the power button
(Fig. 3).
NOTE: Should the pump fail to reach the desired
pressure setting within 15 minutes, the pump will
automatically shut off.
6
Power
button
to cycle between
Mode
button
+
–
or buttons to
Pressure
in PSI
to initiate inflation