Screw Holes - Panasonic TY-ST65PB2 Instrucciones De Montaje

4. Wiring
Insert the clampers ⑥ (6) to the side
of the lower part of the mounting
brackets (right/left) and on the right
and left sides at the back of the
fitting (bottom).
Wire the cables by inserting them
into the wiring guides on the back of
the right and left support columns.
Then attach the stoppers ⑦ (6) to
the wiring guides with the stopper
attachment screws Ⓔ (6).
Each of the right and left wiring
guides has 6 screw holes for the
stopper attachment screws. Use the
screw holes appropriate for your
wiring.
(Tightening torque: 1.2 to 1.5 N·m)
Note
Do not bundle the connection cables
and main lead together.
Fitting the clampers
Lift up when
Fitting hole
loosening
the clamper
①Insert the
projection into
the fitting hole
②After bunching together cables such
as connection cords, pull the end to
draw them tight
5. Preventing falling over
In order to prevent the unit from falling over, fix it
by passing strong cords or wires to the crossover
points (at least 1 location out of the 2 locations on
the left and right) of the mounting brackets and
the fitting (top), and connect them without slack to
sturdy pillars or walls.
(Use commercially available cord or wire to prevent
falling over.)
The distance between the pillar or wall and the rear
of the display must be 1 m (39.4 inches) or less.
Holes for
Clamper ⑥
inserting clampers
Wiring guide
Stopper ⑦
Clamper ⑥
Holes for
inserting clampers
Cables
Cables
Stopper ⑦
Stopper attachment
screw Ⓔ
Strong cords or
wires available on
the market
Stopper
attachment
screw Ⓔ
21