Jones Stephens L65001 Guia De Inicio Rapido página 2

L65001
Cast Iron Sink Instructions
inserting the pointed leg tips into the hollow hexagonal legs, the legs are
sure to cut the leg squarely.
2. Remove the protective covering form the hexagonal leg.
3. Insert the leg end nut into the top of the leg.
4. Thread the 4" leg extension screw halfway into the leg end nut.
5. Screw the lock nut onto the leg extension screw down to the leg end nut.
6. Screw the lug onto the end of the leg extension screw.
7. Place the lug over the molded tip in the bottom of the sink and position
the leg vertically.
8. Rotate the leg to extend the leg extension screw to the point where the
sink is level and its weight is supported by the lug.
9. Tighten the lock nut against the top of the leg end nut.
10. Repeat steps 2 through 9 for the other leg.
Note: Escutcheons and rubber hat washers are not required for this
installation and may be discarded.
TRADITIONAL LAVATORY LEGS
POINTED
LEG TIP
LUG
EXTENSION
SCREW
LOCK NUT
LEG END NUT
LEG
English
2