Pilot TF-408 Guia De Inicio Rapido

SUPER ROTATION FLUORESCENT LAMP (TF SERIES)
QUALITY AND CHARACTER:
Our fluorescent lamp supporters have fashionable and popular new-style. They are luxurious and elegant, beautiful and light,
made in PC high class industrial plastic, assembled with high quality electronic ballast, these fluorescent lamps light up quickly as
soon as switching on under super low voltage, they can be used to light in part of the room, also can be used for decorating. The
optimum choice for you!
PERFORMANCE:
Cat. No. Volts
TF-408 120V AC
TF-508 120V AC
TF-513 120V AC
TF-416 120V AC
TF-420 120VAC
TF-521 120VAC
TF-528 120VAC
TF-535 120VAC
ASSEMBLY/MOUNTING INSTRUCTIONS:
Lampholder
Adding Fixtures:
Multiple fixture can be linked together for continuous runs with the enclosed connector cable. Do not connect more than 10 units.
Fluorescent Lamp Frame
Amps
0.15A
0.15A
0.21A
0.23A
0.29A
0.29A
0.45A
0.50A
Lens
Power wire
INSTRUCTION
WWW.PILOTLIGHTING.COM
Hz P.F.
60Hz 0.53
60Hz 0.53
60Hz 0.58
60Hz 0.58
60Hz 0.58
60Hz 0.58
60Hz 0.58
60Hz 0.58
1.Use template to mark screws locations. (Template is inside package), use a
small drill, or nail, mark two small starter holes at the marked locations. Place
the two small rubber grommets over the mounting screws. until the rubber
grommets contact the bottom surface of the cabinet. Then turn the screws
another 1/4 turn. The screws must be driven in straight for the fixtures to mount
properly. Align the cross hole openings in the bottom plate of the fixtures over
the mounting screws, and firmly slide the fixture over in one direction to lock it
into place. The fixture can slide toward the front, rear, or from side to side
depending on the spacing in your particular installation. The fixture should fit
snugly up against the mounting surface. If not, then your screws need to be
tightened a little more for an improved fit.
2.Connector the power wire.
3.The ways of disassembling and mounting the fluorescent lamp: When
disassemble it, press forward and turn over upward the side of the lampshade
with your thumb. When disassemble the fluorescent lamp, rotated the
fluorescent lamp ninety degrees. When mount the fluorescent lamp, put the feet
of the fluorescent lamp into the trough of the lampholder first, then rotate the
fluorescent lamp ninety degrees.
4. Mount the lens last.
Note: Handle with care to avoid breaking lamp.
Male and female
power connectors
Lamp Size Watts
T4 8W
T5 8W
T5 13W
T4 16W
T4 20W
T5 21W
T5 28W
T5 35W
Power Wire