Publicidad
Connect the DVD Player with the included Bluetooth Headphone
Please follow the below steps to connect your DVD player with the Bluetooth headphone:
The headphones are marked A and B and are already paired with the corresponding DVD unit,
out of the box: Headphone A is already paired with DVD unit A and Headphone B is already paired
with DVD unit B.
In case you cannot connect out of the box or it you used the headphones on another Bluetooth device
and want to reconnect it to the DVD player again, please follow the instructions below.
1. Press and hold the Power bu on of Bluetooth hea
power on" message from the headphone. The headphones power led will flash red/blue.
2. Press the SETUP bu on on the remote control and navigate to the AUDIO SETUP PAGE,
Go to the BLUETOOTH op on and switch it o ON. A Bluetooth
the right corner of
3. Now go to the SEARCH DEVICE op on, choose SEARCH and then press the ENTER bu on on
the remote control to ini te the Bluetooth device search. The player now will show
"Searching...".
4. When "Searching..." is disappeared from the screen, the Bluetooth icon is changed to
you'll hear a short beep from the headphone and the headphone's power led will stop
flashing red/blue.
The DVD player is now connected with the Bluetooth headphone.
A
en
on:
-
To avoid that the DVD player can't find your Bluetooth headphone, please disable the
low power and must be charged.
-
if you find the max headphone level is too low, please increase the volume level on the DVD
player itself.
Charging the headphone ba ery
the headphone and the USB connector to an USB charger (not included) or a PC but you can also use
the USB port of the DVD player (ONLY if the DVD player is powered by the supplied AC adaptor or
Car adaptor).
Remark:
not be used then.
1
2
5
3
the screen.
1. Micro USB
2. Vol-
3. Power ON/OFF
4. Vol+
5. Headphone in jack
4
dphone and release it when you hear the "
t
icon will be displayed on
,
Publicidad
