Raid Setup Procedure - XMG PRO 15 Audio Guia Del Usuario Concisa

RAID Setup Procedure

1. Start-up your notebook computer and press F2 to enter the BIOS
and go to the Setup Utility.
2. Select the Advanced menu.
3. Select SATA Mode, press Enter and select Intel RST
Premium... and select <OK>.
4. Press F10 to Save and Exit and select <Yes>.
5. After the computer restarts press F2 to enter the BIOS again and
go to the Setup Utility.
6. Go to Intel(R) Rapid Storage Technology (in the Advanced
menu) and select Create RAID Volume.
7. You can now setup your RAID volume using the installed SSDs.
8. Select Name and type a name of your choice for your RAID
volume and select <Yes>.
9. Select RAID Level and choose the RAID Level required (see
Table 1 on page 7) and press Enter.
• RAID 0 (Stripe)
• RAID 1 (Mirror)
10. Go to any of the disks listed under Select Disks: and select a
disk name.
11. Click on X to select the disk required.
12. You should select two identical SSDs to form your RAID volume.
13. If you have selected RAID 0 (Stripe) then you can adjust the
Strip Size to your requirements (It is recommended that you set
the "Strip Size" to 128KB).
14. Select Create Volume (make sure you have selected your
disks).
15. The system will list your RAID volume.
16. Press F10 to Save and Exit and select <Yes>, however note
below.
• Make sure the Windows 10 OS (DVD) is in the attached DVD
drive or on a USB flash drive and as the computer starts up it
8
will automatically boot from the Windows 10 OS DVD or USB
flash drive.
17. Click Next > Install Now to continue installing the operating
system as normal (see your Windows documentation if you need
help on installing the Windows OS).
18. Follow the on-screen instructions to install the Windows 10
operating system.
19. Install the Windows drivers (see
the Intel® Rapid Storage Technology (IRST) driver.
page 25). Make sure you install