Lenovo S3200 Manual De Instrucciones página 2

Task
5. Connect power cords.
6. Test enclosure connectivity.
7. Install required host software.
8. Connect hosts.
9. Connect remote management hosts.
10. Use the CLI to set IP values for controller network ports.*
1 1. Use the CLI to set the host interface protocol.
12. Use the web-browser interface to update firmware.
13. Use the web-browser interface to configure and provision
the storage system.
* If you cannot access the Setup Guide, use the following quick-reference information.
Terminal emulator settings to access the
command-line interface (CLI)
Display settings: mode: VT100 or ANSI; font:
Terminal; translation: None; columns: 80
Connection settings: port: COM3 (for
example); baud (bit/sec): 1 15,200; data
bits: 8; parity: None; stop bits: 1; flow
control: None
First Edition, May 2015
Copyright Lenovo 2015.
LIMITED AND RESTRICTED RIGHTS NOTICE: If data or software is delivered pursuant a General Services Administration "GSA" contract,
use, reproduction, or disclosure is subject to restrictions set forth in Contract No. GS-35F-05925.
Lenovo, the Lenovo logo, BladeCenter, Flex System, NeXtScale System, and System x are trademarks of Lenovo in the United States,
other countries, or both.
The material in this document is for information only and is subject to change without notice. While reasonable efforts have been made
in the preparation of this document to assure its accuracy, changes in the product design can be made without reservation and without
notification to its users.
Printed in China
P/N: 00WE605
2 P/N 00WE605, May 2015
As described in
Setup Guide
Storage Manager Guide
Default user Controller IP values
name, password
Default values: controller A IP address 10.0.0.2;
manage,
controller B IP address 10.0.0.3; netmask
!manage
255.255.255.0; gateway 10.0.0.1
Syntax to set IP values for controller A: set net
ip IP-address netmask subnet-mask
gateway gateway-address controller a