How To Clean - Team kalorik Kitchen Originals HCM1000 Manual De Instrucciones

(*) Competent qualified electrician: after-sales department of the
producer or importer or any person who is qualified, approved and
✁
competent to perform this kind of repairs in order to avoid all danger.
In case of need you should return the appliance to this electrician.
!
!
BEFORE THE FIRST USE
Remove all packaging, and check that no parts are damaged or missing.
•
Read these instructions carefully!
•
Wash all parts (except the motor unit!) in warm soapy water and dry thoroughly.
•
!
Wipe the motor unit with a damp cloth.
•
BE CAREFUL!
Your appliance is fitted with a security device on the pouring jug allowing the functioning of
the appliance only when the jug and its lid are correctly placed on the motor base. If those
!
conditions are met and the appliance does not start, call your after sales service.
!
MOUNTING OF THE BLENDER AND USE
Assemble the pouring jug on the motor block. Make sure it is well placed.
•
Open the lid (turn it a quarter turn to the left or to the right).
•
Pour the liquid (water/milk) for 1, 2 or 3 cups into the pouring jug (1 cup = 200ml).
•
CAUTION: DO NOT EXCEED THE MAXIMUM LEVEL!
Add the powder (cocoa powder, coffee powder...) in accordance with the quantity of
•
liquid (as indicated on the packaging of the powder).
Put the lid and make sure it is closed well (position SPOUT CLOSED).
•
If you want to mix and heat your preparation, put the switch in position I. After about 5
•
minutes your preparation will be ready and the appliance will stop. Put the switch in
position 0.
If you only want to mix your preparation, put the switch in position !
•
will keep mixing the preparation until you put the switch in position 0.
Whatever mode you have chosen, you can stop the appliance at any time by putting
•
the switch in position 0.
To serve, turn the lid towards position POUR. Take care when opening the lid: very hot
•
steam might escape. Be careful to avoid burns.
!
Unplug the appliance.
•
!

HOW TO CLEAN

Before attempting any cleaning operation, make sure the appliance is unplugged from
•
the supply socket and fully cooled down.
The accessories can be cleaned in warm soapy water but do not use any abrasive
•
cleanser or scouring pad as these might damage the surface.
For a quick rinsing of the pouring jug (for example between two preparations), you can
•
use clear water and switch on your appliance for a few minutes with the switch in
position I. In this case, do not use any detergent.
For a full cleaning of the pouring jug, remove it from the motor block. Then you can
•
clean it with soapy water and rinse thoroughly with clear water. Dry before assembling.
From time to time you can also take off the mixing paddle. To do so when the
•
appliance has cooled down:
Remove the pouring jug from the motor block.
−
Take the part of the mixing paddle that is situated at the bottom of the pouring
−
jug (gearing) with one hand and turn the part that is situated inside the pouring
jug clockwise with the other hand.
Clean and dry the mixing paddle and the inside of the jug well before
−
reassembling.
12 !
! !
Assembly page ! ! ! 12 42 /!
! !
!
. The appliance
TKG HCM 1000 - 150121