Product Overview - LEGRAND C2G30014 Manual De Instrucciones

HDMI Ultra-Slim HDBaseT + RS232 and IR over Cat Extender Box Transmitter - 4K 60Hz

Product Overview

Front Panel
Transmitter
F P D
RONT ANEL ESCRIPTION
On: Power is applied to the device.
1 Power LED
Off: No power is applied to the device.
Blinking: The device is working properly.
2 Status LED
Off: The device is not working properly.
On: HDCP protected content is being transmitted.
3 HDCP LED Blinking: Non-HDCP protected content is being transmitted.
Off: No content is being transmitted.
On: HDBT link is normal.
4 Link LED
Off/Blinking: No HDBT link or link error.
STATUS HDCP LINK
4
1 2 3
Rear Panel
5 6
R P D
EAR ANEL
Connect the power adapter provided.
5 DC 18V Note: The power adapter connected to either transmitter or
receiver is able to power on both units.
6 HDBT OUT Connect to the receiver via a Cat 5e/6/6a cable.
7 IR IN Connect to the IR receiver provided.
8 IR OUT Connect to the IR emitter provided.
9 RS232 For RS232 pass-through.
10 HDMI IN Connect to an HDMI source using an HDMI cable.
2
Transmitter
IR IN IR OUT TX/RX/G HDMI IN
7 8 9 10
ESCRIPTION
(us)
(us)