V-TAC VT-4016–5 Manual De Instrucciones página 9

FIG 10
Step 10. Move the clips around the outside edge of the front guard outwards (see figure 10).
Step 11. Hang the front guard (1) over the top of the rear guard (5) (see figure 11).
FIG 13
FIG 11
Step 12. Bring the front guard down to meet the rear
guard and push the clips inwards until the front guard is
fastened to the rear guard (see figure 12).
Step 13. Finally fit the guard nut and screw (arrowed)
through the holes in the bottom edge of the guards and
tighten with a suitable pozidrive screwdriver (not supplied).
Note: this screw and nut must be fitted so that the guard
cannot be removed (see figure 13).
ENGLISH
FIG 12