Maintenance & Cleaning - INVENTOR INVMS93A2 Manual De Usuario

9. MAINTENANCE & CLEANING
• Allow the appliance to dry for
approximately 1 to 2 hours.
• Set thermostat to middle position. Plug
into a power source. The appliance will
chill continuously until set temperature
has been reached.
• Frequently the air vents and the
condenser must be cleaned located at the
rear end of the appliance, using a vacuum
cleaner or a brush. The condenser should
always be clean, free of dust or any other
impurities.
EN
• Do not use abrasive products, abrasive cleaning pads,
solvents or metal objects. Do not use water spray and
steam to clean the appliance.
• Do not use extreme moist cleaning pads. Any moisture
around the electric components, should be avoided.
• The use of a steam cleaner is prohibited, as this may
be very dangerous.
Prior to cleaning the appliance, un-plug
from the wall power socket, and remove
all shelves.
• Clean the appliance with a moist soft
cloth. Use only neutral detergents.
• Clean the unit's interior with a weak
bicarbonate soda solution and rinse with
warm water applying a damp sponge or
cloth.
• Use a damp cloth to clean the exterior,
keep in mind the door must be shut to
avoid getting any polish on the magnetic
door seal or the interior of the unit.
• Upon cleaning, rinse the interior with
clean water and dry.
Clean the
interior of
the appliance
ONCE A
MONTH
13