Pre-Setting The Duration Of Treatment; Re-Setting The Timer - IBP TENS WL-2103A Manual De Instrucciones

38
IBP_WellTENS_01_GB_DR.indd 38
All the following settings apply automatically to all three operating
modes.
3. To set the pulse width, turn the pulse width selection dial until it reaches
the desired setting.
4. To set the pulse rate, turn the pulse rate selection dial until it reaches the
desired setting.
5. Close the faceplate.

10.2 Pre-setting the duration of treatment

1. Open the faceplate.
2. Slide the sliding switch to select the duration of treatment to one of the
three possible settings:
Setting Duration of treatment
Unlimited duration of treatment
C
30 30-minute treatment
60 60-minute treatment
When the pre-set duration of treatment has elapsed the stimulation stops
automatically and the LED displays go blank.
3. Close the faceplate.

10.3 Re-setting the timer

1. Switch the Well TENS off.
2. Switch the Well TENS on again.
The timer will be re-set.
The pre-set duration of treatment will re-start from the beginning.
01.03.2006 11:08:34